kombinierte Belastung:

$\backslash sqrt\{\backslash left\; (\; \backslash frac\; \{F\_\{1,d\}\}\; \{R\_\{1,d\}\}\; +\; \backslash frac\; \{F\_\{4/5,d\}\}\{R\_\{4/5,d\}\}\; \backslash right\; )^2\; +\; \backslash left\; (\; \backslash frac\{F\_\{2/3,d\}\}\{R\_\{2/3,d\}\}\; \backslash right\; )^2\}\; \backslash le\; 1$

¹⁾  b = 75 mm ; e = 130 mm

Combined load:

$\backslash sqrt\{\backslash left\; (\; \backslash frac\; \{F\_\{1,d\}\}\; \{R\_\{1,d\}\}\; +\; \backslash frac\; \{F\_\{4/5,d\}\}\{R\_\{4/5,d\}\}\; \backslash right\; )^2\; +\; \backslash left\; (\; \backslash frac\{F\_\{2/3,d\}\}\{R\_\{2/3,d\}\}\; \backslash right\; )^2\}\; \backslash le\; 1$

To obtain the resistance values for a single bracket, the values in the above table should be divided by two, provided that the supported beam is locked in rotation. Please consult our ETA-06/0106 if the beam is free to rotate.

* Refer to Characteristic Capacity table columns for type of fasteners that can be used in Flange A. Capacities vary depending on fastener type used.

1)  b = 75 mm ; e = 130 mm

Refer to the Simpson Strong-Tie anchor product range for suitable anchors. Typical anchor solutions are BOAXII, SET-XP, WA, AT-HP, depending on the concrete type, spacing and edge distances.

Combiend load : 

$\backslash sqrt\{\backslash left\; (\; \backslash frac\; \{F\_\{1,d\}\}\; \{R\_\{1,d\}\}\; +\; \backslash frac\; \{F\_\{4/5,d\}\}\{R\_\{4/5,d\}\}\; \backslash right\; )^2\; +\; \backslash left\; (\; \backslash frac\{F\_\{2/3,d\}\}\{R\_\{2/3,d\}\}\; \backslash right\; )^2\}\; \backslash le\; 1$

To obtain the resistance values for a single bracket, the values in the above table should be divided by two, provided that the supported beam is locked in rotation. Please consult our ETA-06/0106 if the beam is free to rotate.